Durahl

So, here's my take on the suggested changes... In the first two pictures the Filament now enters the PTFE Tube without the chance of forming a Kink:   The...

That part with the under extrusion looks like that _because_ I was having those issues - I just barely managed to print _that_ one as an unbent stopgap before settling...

Fair enough, but where do I find the PrettyGCode folder / camera-controls.js file? 😅 I tried looking for it via an FTP Program but I'm having a hard time finding...

The 2nd path it was! I'm using FIleZilla, I assume either works 😉 Though I cannot test it with a 10h print running in the background and with that I'm...

Weird... Must have gone lost when I shuffled stuff around for readabilities sake 🤔 Added it to the end of the OP

[Happy Hare V3](https://github.com/moggieuk/ERCF-Software-V3) - which I've been running on my Setup for a while now ( and which I can **_HIGHLY_** recommend! ) - now seems to be running this...

Soo... When I config the Widget with the `Simple Mode` it'll work but said mode doesn't contain the required Settings:  When I config the Widget with the...

Below is Photo of it:  It is basically large enough to bleed into all the surrounding Widgets ( `top_left`, `top_right` and `middle_center` ) and could probably do with something...

Sorry for the "late" reply... I had actually prepared my response with my findings but apparently never sent it? 🤔🤨 Adding `width: 400,` worked like a charm, even the suggested...

 The `Goto XYZ Zero` Keyboard Shortcut is eternally bound to the offending `G0 Z5, G0 X0 Y0 Z0` Command which quite frankly should be removed **AND** being replaced with...