Dominik

When exporting the model as STL and re-importing it, the issue is gone. Same if I then save the 3MF and re-open it, no issue slicing it. Not sure why,...

Hi, could you please attach the 3MF for this file, or any file that helps us understand and reproduce the issue?

Basically [Pressure Equalizer](https://help.prusa3d.com/article/pressure-equalizer-_331504), but for every corner? How would you define such a corner, what's the angle threshold? What about very complex models?

In theory, this would be interesting I think, but I still see a few issues with this. Corners are rarely perfect (i.e. line to line), and there are often one...

It is however the same issue or at least very similar to #8700. @hejllukas Enough to close this one again?

> From the results in the development thread, that seems nowhere near ready for primetime. Again, just the option to specify what size of gap is worth filling would solve...

> Just tried a print; Arachne has already fucked up my seam placement (I selected “rear” but got diagonal) and seems to have poorer dimensional stability. The ring of ripples...

I wanted to leave a small heads-up that this is not exclusively happening with fuzzy skin, but with any modifier that causes specific changes to the perimeters. A good example...

Most resin prints should be printed with a pad and supports, where an elephant foot wouldn't cause any issues. But for models with a flat surface to place it on...

Usually, if something is requested a lot but not implemented over a longer period, there's a good reason for it. Examples of such reasons would be: - Implementing this would...