Doug Joseph
Doug Joseph
I have the same TwoTrees laser rig (TTS-55) and the MKS touch screen (MKS TS35-R v2.0). I had flashed a DLC32 firmware version 2.3, as I was hoping for landscape...
UPDATE: Whenever I tried the latest version of the DLC32 firmware, for "Board_v1.0", the laser would not fire. However, I then backed the firmware version down to 2.0.8_H35, dated Jan...
> This error occurs when you update your TFT firmware and forget to change config.ini to not load ABL settings on startup. If you change `auto_load_leveling:1` to `auto_load_leveling:0`, save the...
Thanks for answering. It's been a while since the report, and at this time I don't remember which of many domains was the source of this report.
May be what is called "ghosting" ??? https://3dprinterly.com/3d-printing-ghosting-ringing-echoing-rippling-how-to-solve/
Also, I'm a little confused about this step in the directions: > config.txt - replace the last section with: > > [pi0w] > enable_uart=1 > dtoverlay=pi3-miniuart-bt My config file has...
Another note on this effort. It dawned on me that the firmware.bin (klipper.bin) file may have needed other settings, and printer.cfg might need to be different. I located this sample...
UPDATE: Please disregard. Since it seems this thread is about iOS, while my situation is MacOS, I started a new issue here: https://github.com/utmapp/UTM/issues/5678 I don't know if I need to...
> Change FileSizeLimitInBytes to 0xFFFFFFFF hex or 4294967295 decimal and click OK This also worked for me, however, for some reason, the copied and pasted hex value was never accepted...