Extrutim comments

Repositories
Issues
Comments

Results 3 comments of


                                            Extrutim

[BUG] Missing outer perimeter.

I have the same problem (Firmware 6.1.2+7894) and the frequency has increased in the last few weeks. I now have this issue in almost every print, in the beginning it...

[BUG] When preheating to unload filament on any tool other than Tool 1, the printer will start heating each tool head.

I have the same bug, now over several firmware versions (5 tool). I can reliably reproduce the bug, when I change a filament on e.g. E2, E1 is automatically heated...

[BUG] XL does not turn off hot end after load or unload

I have the same problem (firmware 6.1.2+7894). No matter in which extruder I change the filament, E1 is heated to 170°C afterwards. This remains set even if you start a...