Doormat1

The instructions in the manual dont work however this does - https://www.makeuseof.com/connect-to-wifi-with-nmcli/

Is your fpc correct? It needs to be the reverse kind, where the pads are on each end are on different sides of the cable. If it is the other...

The instructions in the manual dont work however this does - https://www.makeuseof.com/connect-to-wifi-with-nmcli/

Did you try following the instructions I linked and do it through terminal when connected over Ethernet

No will give that a try On Sat, 29 Apr 2023, 21:56 DarKingF0x, ***@***.***> wrote: > Did you uncomment the tft settings in the boardenv.txt (root of sdcard)? > >...

What screen are you using? In the end I gave up with the gpio screen, (pin order on the board is not the same as a pi I believe was...

Have you removed the # from the line in boardevn.txt? Also check your ribbon cable, the connectors can be mirrored. I found that I needed a ribbon cable where the...

Ah it's on the log in page. Have you read this https://klipperscreen.readthedocs.io/en/latest/Troubleshooting/