Daniel Loranger
Daniel Loranger
I found with my printer the ratchet wheel the inner teeth were too rounded and I tended to have 1-2 teeth where the ratchet would not catch to continue driving...
I found springs on amazon that met the design specifications, but I am finding they are too weak to ensure a proper ratchetting. Can you either provide a source for...
just to make it all uniform and error free for other users besides those of us running the 3d printer side
I see you run a grey and black color schema, curious if this is necessary, or if it was an arbitrary decision? I understand the value in keeping the two...
Not sure what you're setup is, but I have my PNP on a plywood table and need a way to permanently affix the base plate to the table. Sure tape...
I am finding that the solution implemented in #538 is not a complete solution that still leaves the initial issue of moving gpio locations unresolved when using the gpiochip### approach...
When code changes get stabilized, can we get a fresh release version?
I have noticed I have to reboot the pi to get gpio changes to be reflected in the file system when restarting the svxlink service should be sufficient for example...
I have been looking through the options and feel I must be missing something. How to configure the svxlink-server to accept a GPIO for both COR/COS and CTCSS. The configuration...
working on a setup where the idents are disabled, but during a QSO the system idents every 2 minutes or so when the sql is dropped. I have chased the...