Digisembler
Digisembler
Doh, I meant to print it yesterday before I left. i'll try again at home for a full array print (which fits on my ender 3 at 45 degrees). Last...
Created/Emailed top and side views to @cactus314 to update graphics for magnet polarity.
another idea, to add a help button on GUI, it could either show what to do, or take user to wiki page. ... develop a user map, to show where...
1% is correct, as the model is apparently full size. Checking my 3mf file I used to print, i noticed i had already scaled it there, and forgot that when...
Got most of Starliner uploaded (SM is too big, even zipped). Added the attributes for Cygnus and Starliner and HTV.
Finally got the stl model uploaded... Still need to get the fusion file to Sam.
Thanks @cactus314 ! I was noticing on the 2nd build we're working on that we might end up with side mounted L brackets to help stiffen the short vertical pieces...
So... Leonardo/PMM and Columbus are the same "can" (there were 4 cans built, 3 as MPLMs, 1 as Columbus). Since the Columbus is the only one with the "back porches",...
I've found that if one uses a drill bit, this is immensely helpful to enlarge a hole that might be slightly undersized from printing on a potentially less than superbly...
Same sort of thing here (ish). i have version 1.1.11 on cura 4.5. slices fine, saves fine. When i go to run the file on my makerbot replicator 2x, that's...