David Dreschner
David Dreschner
It's not really needed, more like a "quality of life" improvement. As you mentioned, I already implemented a `toZigbee` converter to trigger the adaptation manually. It's necessary to do after...
My guess is that the update worked and just the displayed build id and build date is wrong as it's cached. Could you check the response in the dev console...
Hmm, that's strange. How does the information in the state tab of the top thermostat look like? Did you remove the batteries of the BTH-RA for a few seconds after...
@mmattel : Did you got any errors during the update? Or did anything with the device at the end except maybe pushing the button when the calibration is requested? I...
@mmattel : Mhm, I see. It would be great to have a debug log from when this occurs. I also had a "invalid image" at the end of the firmware...
@hmaiss : Did you use Z2M version 1.35.0 from monday for the update?
Hey there, I try to setup my Miele washing machine. Unfortunately, I run into the same timeout error when using my Nginx SSL proxy. When accessing the HA instance directly...
Hey again, guess I found the problem. I have a native IPv6 internet access and distribute a public IPv6 address to each device in my network. After disabling DHCPv6 for...
FYI: The CB1 is supported by Armbian. This build is maintained by BigTreeTech and is based on Debian 12. You just need to install Klipper manually via KIAUH if you...
FYI: The CB1 is supported by Armbian. This build is maintained by BigTreeTech and is based on Debian 12. You just need to install Klipper manually via KIAUH if you...