Derrick

I name all of my octoprint instances and I use static IP's with names so I can identify what printer it is I am trying to connect to so this...

After much wrangling I was able to get it to work after a reboot. 

> This looks like an apt issue to me. Unfortunately I am not familiar with the octopi and its tweaks and differences from raspbian. That is Raspbian. 

I am way ahead of you. I already setup a PI with the stock Raspbian image to test it there when I made the post. I'll let you know if...

Any updates on this under extrusion issue? I noticed it was under extruding and found your Github while looking for a solution.

That issue with the firmware showing filament is 3.0 I saw as well. @andyfarthing. I had also tried to calibrate esteps and it was under extruding with a default of...

When I went back to the stock firmware it didn't under extrude. I am also using Microswiss. I haven't recompiled the firmware yet since I am working on my CR10...

I also had this issue and I had never seen it before until after I installed Beta 3. I was running Wanhao V09 before that.

@dot-bob Are you going to update this branch now that Marlin 2.0 stable is out? The stock Marlin 2.0 Wanhao D6 example config failed due to a sanity check. We...