Blake

I will also have a few boards that I will have left over, but they will not have the screen or battery installed. Those are easy additions though.

Single sided soldering at JLCPCB could be pretty good guidance for most since it allows for many of the small components to be added and only requiring the buttons to...

I think having a hub feature may be nice, but I suspect that would be a bit down the road since I think there are other more important features currently...

@hypercube33 If you plan to design some sort of hub, it could be possible to just use the Bluetooth LE or just the LAN to connect the two, then you...

I think the hub will be a good idea, But I assume that will not be a main priority since the software will likely be in flux for a while,...

I also believe this would be a good feature, But I think for right now I will just end up using an outboard IR receiver to read the IR codes...

Just adding an idea that could help with IR command learning, could the commands be added into the eeprom locations to allow dynamic changing without needing to hardcode into the...

Just a thought, If adding IR learning functionality on-board may be difficult, an IR reading mode could be implemented that could spit out the received IR signal to some serial/http...