Dani7710

> The error you're encountering indicates that there was an issue installing the build dependencies for the `ninja` package. This package is required for the installation of `klipperscreen`. > >...

> > > The error you're encountering indicates that there was an issue installing the build dependencies for the `ninja` package. This package is required for the installation of `klipperscreen`....

> ls -al /dev/ > > > > > The error you're encountering indicates that there was an issue installing the build dependencies for the `ninja` package. This package is...

> Try running: ls -al /dev/ Check for a device like ttyACM0. Or you can save the output of running the above command as a TXT file and send it...

> > > Try running: ls -al /dev/ Check for a device like ttyACM0. Or you can save the output of running the above command as a TXT file and...

> > > > > Try running: ls -al /dev/ Check for a device like ttyACM0. Or you can save the output of running the above command as a TXT...

full report [ 1871.866771] [0: kworker/0:1:11792] usb 1-1: new full-speed USB device number 4 using xhci-hcd [ 1872.010547] [0: kworker/0:1:11792] usb 1-1: udev->lpm_capable=0 [ 1872.048615] [0: kworker/0:1:11792] usb 1-1: New...

$ dmesg | grep 1-1 [ 119.835217] [0:irq/276-sm5713-: 2494] sm5713_ccic_event_work : usb: DIAES 4-1-1-1-0 [ 119.835681] [0:irq/276-sm5713-: 2494] sm5713_ccic_event_work : usb: DIAES 1-3-1-1-0 [ 120.210434] [2: kworker/2:2: 5358] usb 1-1:...

this is the printer.cfg of flsun original speederpad which is officially supported and for sale as klipper upgrade, finally sonicpad and speederpad are tablets... and below mcu has these lines...

> You can already set brim on/off by object.  however there are large objects that need to have the brim only on protruding corners, I think the ability to...