DaneEvans
DaneEvans
Apologies, you're right. I looked at the wrong pcb file! Given that the mini-e's have 0.8 mm behind the LED, you're right and the downward pointing LED's will not work...
Because of our double sided design, it's the easiest way to think about the geometry: For the underkey ones, the LED is mounted on the bottom, and the light points...
I think they are meant to be facing down.. Is it currently in a state to merge? Or is the LED orientation still outstanding?
Not out of the box, but feel free to do up a board. They are still 5v, so it should just be a footprint swap. But I can't imagine that...
There is on the RGB plates Run some M4? Bolts through the extra holes in the PCB, add standoffs to your preferred height. Adding a thumb screw to the bottom...
I think I got warnings from the automated tool, which I ignored. It's a hobby board, I don't need it to last 10 years and have 100% yield. Definitely no...
Try measuring the other way between GND and VCC, or do so without the micro attached. There definitely shouldn't be a short, but you are probably seeing a diode between...
See, with an image we can help. Read the build guide, and pay attention to which side of the board the OLED jumpers are supposed to be on. And where...
If you use the jumper pads to swap the order of them - ie 1>4, 2>3, 3>2, 4>1, or reverse the OLED, both should work. The first would be cleaner....
How is this not present in any shape or form? As far as I can tell, you can't even remove someone from your followers list.