Cysign

Steps 1-4 are identical. But step 5 is impossible, as the LPK25 wireless isn't detected. When I open the usual bluetooth menu on the tablet I do see the LPK25...

It's not paired. As soon as I pair the LPK25 using the system's bluetooth dialogue, it's paired, but not connected (even on my phone where I can connect to it...

Here's what it looks like: https://youtu.be/JcQiYYrDE3s

I restarted the tablet and the behavior is exactly the same as before. Bluetooth sestem dislog: I can see the LPK25 wireless. Midi Ble connect-app: I can't. I doublechecked it...

Exactly the same behavior as before. Midi Ble connect can't find the midi device. Here's the current software and tablet version:  

Same here. Did anyone fix this?

By removing line 440 and line 475 I was able to compile properly. line 440: if (usart3 == USART3_OFF) power_usart3_disable(); line 475: if (usart3 == USART3_OFF) power_usart3_enable();

- Add info about voltage/maximum current for the laser connectors - Add instructions to setup the stepper current properly - Add checklist 'before you turn on your machine'

- Add information if a resistor for an DIY-WS2812 strip is needed on the signal - Does the Hat deliver power to the Pi? - Add: Use some tape on...

Hmmm.....same here. I already checked line 203 and (on my fresh re-downloaded LC-i2c-lib) it already is return = 1. Any other suggestions?