Cougar

I like the Tampermonkey/Greasemonkey idea. Easy to install it unnoticed when *monkey is used ;-)

The problem is only with `MYSQL_USERNAME` but your fix is wrong here. Your change won't keep empty variable and therefore it is not possible to put username and password in...

I think that these errors are also related with docker dynamic interfaces that may disappear during data collection ``` ts=2021-12-10T05:54:07.586Z caller=collector.go:169 level=error msg="collector failed" name=qdisc duration_seconds=1.290457509 err="route ip+net: no such...

I'd like to second on this. It is not just a calibration issue. Maybe even another issue should be created. I did a simple test with three meter boards, all...

I first suspected some sort of initialization problem because not all setup registers are written in the boot. However, based on spec it should not be a problem and defualt...

@CircuitSetup My first post was power cycle. I moved the whole setup to another room and lost all my "good" calibrations. Most resets are software resets that ESPHome does when...

I 100% agree. I read only first voltage from every chip. I will try to read all three to see if there is any inconsistency between them too. Of course...

I tried to reset chips during operation and this didn't change anything. However, the whole ESPHome reset almost always did. My transformer is 9.0V 0.67A (6.0W) which should be enough...

I modified my board a little bit to remove board power from AC transformer. The easiest was to just remove a rectifier from the board and supply power to ESP...

I'm not sure if the stock firmware is any way different. I updated around ten thermometers today from original and ATC to the latest ATC release and one of them...