ClockSelect

Sweet algo differ from factory algo only after temperature stabilization; you should not experiment a different overshoot of the set temp between the two. Theorically, you'd have the same result...

Algos may work better or worse than the default depending on your setting; that's why the manual states that there's no "best" algo. It always depend on what you have....

Maybe it's just that the sweet algo is not thruly adapted to your setup; we should look at monitoring curves to have more insight on this. Or did you try...

Right solution would be to store liquid among with puff counters, but it's a bit more tricky than it sounds. It's on a todo list somewhere...

The [commits tab](https://github.com/ClockSelect/myevic/commits/master) is more or less an acceptable changelog.

Beware you may sometime think the mod is off while it's not. If you use a screen saver, the mod switches off at the end of the screen saver duration;...

Revert to stock firmware, wait 5 minutes to be sure, then connect your USB cable. Does it wake up?

@ajape1 it's another subject. See #115.

Found the USB issue: you just lose the USB wake-up ability when LSL mode is ON. Restoring this ability would increase power consumption for something not really usefull, IMO. I'll...

I'm afraid it's not neglictible. I can't tell since I can't really measure yet, but the datasheet of the MCU tells you that PLL clock is not really ascetic. I...