Bryan Mayland
Bryan Mayland
> @CapnBry Found the issue.. my address was 0x77 and not the standard 0x76 Ahhh fudge, I was worried it might have been this. I was looking last night and...
Modified I2C base class to have static member that holds the detection address and detected address. Somehow works out to be 6 bytes less code, but 8 bytes more RAM....
It is the only way to flash SIYI TX devices, which people use. Our PIO build supports it, what's .... what ... what is flasher.pyz? That's binary_flash.py? Can't we just...
I'm so very thumbs down on this idea. It is bad enough that we shout it from every documentation page, webpage, discord post, and media outlet we can that CH5...
I also use cncjs and a virtual COM port on windows with an esplink as well. Just came looking to see if there was any chance of cutting out the...
I haven't had a chance to review this (or experiment with it) but it is on my TODO list. Will get to it!
I bought a Skystars KO45 (4-in-1 3-6S 30x30 ESC BLHeli_32 45A) which uses the SKYSTARS_KM45A_Butter_128K_Multi firmware and it also was doing this on 32.9. Almost every crash one motor would...
I'm all for collaboration on this as well. I had written up some protocol documentation mostly because people kept asking about it and it was easier to direct them to...
No the failsafe is completely external and compiled in so there's no way to adjust it after the fact. Adding failsafe to the ExpressLRS code will be done at some...
https://github.com/crsf-wg/crsf/wiki/Config-Protocol