Budavaril

I saw this button on the schematic diagram (sheet5 bottom left), but I believe this is the "normal" reset button what is physically on the top right corner of the...

Hi, Why better to use those irregular pins (example servos pins) than using same standard pins (aux2-aux3)on any other ramps based boards?

That make sense. So may that's why I had a some trouble with my FLsun i3 during TMC2130 upgrade? I using my board with "dual screen" . One of the...

I tried using the bugfix-1.1.x (not enabled the SW serial yet)and steppers are working looks well, but if I start a print (from pc or from the touchscreen's SD-USB) the...

Thanks your quick response. So it was strange. I uploaded previous 1.1.6 version what was working before, but got same problem. I removed the USB cable, restarted the printer after...

 I still try all adviced upgrade, but not better. I tried cooling with a 5015 blower fan from chip side, other 2pcs 40mm from "cable side) but result is...

Ok, I have 5pcs brand new "old type" driver and those heatshinks doesn't fitted yet, so I can using them instantly on the chips. Let's try.. I just don't understand,...

I haven't got that "overtemp" error message after changed that 1.1.8, not with my chained wire and not now with "parallel" cables. Not on 1.1.6 and not on bugfix 1.1.x....

Thanks all of that, now I understanding better how works. First my outputs: M503: 11:14:37.492 : echo: G21 ; Units in mm 11:14:37.493 : echo: M149 C ; Units in...

Wow.. No output.. Possible??