Botched1

100%. Since there is no unique_id, you can't put the sensors in areas at all... At minimum add unique_id for sensors, but even better would be to add them as...

Unfortunately, no idea. As long as the thermostat has been properly excluded from a vivint panel it should work. If it was paired to a vivint panel, and not excluded,...

I also have a Zooz 800 usb tick, so posting here to follow along as the thread is updated.

I have 103 devices on my mesh (74 repeater, 29 battery), and I have only seen nodes go dead a couple times in the past year. Certainly not daily, weekly,...

Odd. I currently use a uzb7 on US frequency, in case it matters. No dead nodes. Anyway, that is probably a better discussion for a different thread anyway, so we...

> Unlikely, newer devices are specifically tested with Supervision. @InovelliUSA any idea why the device (VZW31-SN) would not accept parameter changes? Was there a firmware update changing parameter sizes or...

Is your device paired in LR mode though? Mine works fine when NOT paired in LR mode. It is only in LR mode it acts odd. And mine acts odd...

Sorry, no I did not. I assumed that since this appears to be a device firmware issue, and not a Z-Wave js issue, that the issue on here should be...

In the end this appears to be a bad device. Somehow the memory is corrupted to the point that configuration parameters can not be changed paired in mesh or LR...