BlackEdder0815

Thanks for the list. According to this list, the “heating end-point” is only visible, when “Sprachen_DANSK” is set. This doesn’t make any sense to me… Or do I read/interpret this...

Thanks for the very quick response. the „intervalacts“ parameter is set to default. So it‘s 55555. I will reduce the setting and will re-try.

Because of x-mas it took a moment to get back to this project. I enabled the "advaced data" accordingly and set the intervalacts to 1000. So the data for this...

unfortunately not. So at least the latest mqtt-message doesn't contain the full data. See the logs. - the relevant device is the **D5:4F:3B:88:E8:1E**. There is a first mqtt-send send with...

Ah wait, I was confused by the sys-message, what was following. Also the first one had no decoded values. So I still have the issue, that only in rare situations...

Thank you very much for your support. I have three Outdoor Meter devices. Currently two enabled by plugging in the battery. They are currently on factory settings. I only paired...

Found no settings in the app to change the behavior of the devices. Also pairing didn’t change the behavior. interesting: using BLE Hero (iOS) I see the full Bluetooth information....

Maybe there is another issue, as I have some artifacts inside the logs. Or is this currently a bug? See this: ``` N: NF: oDund evi5ce detected: D5:4F:3B:88:E8:1E N: NF:...

Ok, continuing the research. I switched to the latest dev right now (setup-from-scratch). Also I fired up mqtt-explorer to get time-stamps. I added the "only sensors" flag, but then the...

Took me some time to get 1.6.0 running on the ESP32. But I managed the installation. I have the same behavior in the 1.6.0. Here is an example: ``` {...