Badnoob

we are seeing some cases of this and were all the way back to beta. Thought we had fully addressed it, but I can see its still happening in some...

"This part has thin voids inside it (blue). When the part is sliced, these produce internal ribs which strengthen the part. If your slicer closes these up, recheck your slicer...

it appears that some MGN12's have a different chamfor spec than others, I will update the STL.

> I was looking at the CAD for the Tap an noticed interference between the MGN12 carriage and the tap_center component. I printed the STL in the repo, mounted the...

I think this can be closed now, thank you for your feedback.

from discord user "Carlos Diegues"  this appears to show significant and uniform deformation in Z

from discord user"Pajtaz" 

> Hatchbox abs printed @250c. Chamber temp is around 50-55c normally while heat soaked. About 200hrs printing. Had to retighten center rail 4 times already and as time went on...

> Stealthburner with Rapido and Tap. After roughly 100 hours of printing in 50 to 60 deg C chamber, printing one filament at 245 for 60-70 hours, and another filament...

the fact that you are getting warping all the way to the center part of tap indicates this likely isn't something we can fix with a design change to SB...