Ashok12698

Before magic 5 baud. Before setting port. After setting port. Timeout on read 0x55. init_success:0 Looping Before magic 5 baud. Before setting port. After setting port. Timeout on read 0x55....

Yes, I agree, [this line] returns false. basically my ECU is a simulator and I can set the modes using switches to KWP and ISO9141-2. So I am trying with...

Hi @ROBOTIS-Will , thanks for your answer but since first I am simply trying to test the provided example (on openCM904) as explained below, nothing happens. This is what defined...

Hi @ROBOTIS-Will, thanks for your suggestion. Since I don't have LN-101, I tested it with similar kind of `"USB to TTL Dongle"` connected at 24(Tx) and 25(Rx) and GND of...

Hi @ROBOTIS-Will , thanks for sharing the test code. I followed it and found that.... -sending data from `openCM to PC `works fine. -sending data from `PC to openCM `doesnt...

Thank you @ROBOTIS-Will for your kind explanation. 👍

I am too facing the same error.... ~/MIPI_Camera/RPI $ ./arducamstill ``` Open camera... Hardware platform: a03111 Found sensor ov7251 at address 60 init camera status = 4100 ``` Please suggest~

Thank you @eyyupT fro your prompt reply. :) well, I tried that and corrected the path to .lib since opencv310, now includes a lib package as opencv_world310.lib. It runs partially...

Hi @coryjfowler @SketchThis I am using CAN-BUS Shield on top of Arduino Uno. I am facing the similar errors like above. Message Sent Successfully! Message Sent Successfully! Entering Configuration Mode...

Hi @coryjfowler , Thanks for your comment. I guess, 'robotdyn' stopped its production but some information you can see on here. http://useshop.co.kr/shop/item/5355132/ This shows the CS pin 10 as shown...