Eric Callahan

One additional comment...I believe that your proposed changes wouldn't just revert the pending changes to the profile, it would remove that section entirely if it exists in the autosave section...

> I don't want to remove a saved profile. I want to avoid saving the current mesh, potentially overriding a profile. Understood. The default behavior of `BED_MESH_CALIBRATE` is to save...

This appears to be in the wrong repo. Moonraker doesn't control UI elements, I suspect you will want to provide your feedback to the Mainsail team.

Thanks. For the record, Moonraker does not provide default values for the `trusted_clients` option, its entirely up to users to configure. I wouldn't want to inadvertently authorize IPs the user...

Hi. As per the discussion in the last PR, I don't think its a good idea to add this option. I understand that a 180 degree rotation is effectively a...

Thanks, I have a few questions/comments based on your initial feedback. > No apikey/auth support Is this a limitation in Prometheus? Does it support any type of authentication? > Experience...

Kevin's suggestion will work, it takes advantage of the range checking built in to the `configfile` implementation. A value outside the specified range would result in a config error. It...

I suspect this is in the incorrect repo. If you need help with Probe Calibration I recommend asking on the [Klipper Discourse](https://klipper.discourse.group/new).

To answer your second question, yes, it is possible for Katapult to flash Klipper over Serial, provided you configured Katapult correctly. If you chose `USB` as the communication interface then...

> Any other ideas what I could check / test to get katapult working? Unfortunately I don't have much more guidance to give. I would check to make sure the...