Eric Callahan

I'm bumping this. This issue is nearly one year old. Please release the schematic.

I think this is going to come down to whether or not Kevin wants to maintain low level SDIO support in Klipper that is only functional for this specific use...

I'm currently in the process of reviewing this PR, I should have it done either tonight or tomorrow. I would recommend holding off on adding H7 support, it would probably...

I have added some initial review comments. Overall the sdio implementation looks similar to what I came up, however I did want to bring up that when researching the stm32...

I went ahead and reopened since Cyberdeck indicated that it may take a bit of time to update the PR.

I'm not sure there is much I can do here, however if you attach the full log I'm willing to look at it. That snippet is an error logged by...

I'm glad you have the configuration issues resolved. With regard to extending the notifier to "work around" the issue with mattermost, its ok if you want to create a feature...

It sounds like Klipper was built with an incorrect configuration. If you used the same configuration to build Katapult's deployer then your device is bricked. DFU doesn't work on the...

FWIW, to get you started, you'll need a programmer like the following: https://www.amazon.com/HiLetgo-Emulator-Downloader-Programmer-STM32F103C8T6/dp/B07SQV6VLZ/ref=sr_1_1_sspa?keywords=st-link+v2&sr=8-1-spons&sp_csd=d2lkZ2V0TmFtZT1zcF9hdGY&psc=1 Once you have it, you wire it up the the SWD pins on the board, close the...

The SKR Pro has a design flaw that prevents it from entering DFU mode. IIRC it has to do with the capacitors on the crystal.