ArjunaJames
ArjunaJames
Jim Arjuna HavenMade Broomfield, CO +17202824692 On Mon, May 20, 2024 at 5:32 PM GregValiant ***@***.***> wrote: > Thanks for the report. > I'm not able to duplicate this and...
What I think is happening is the Z for the supports is .3 lower than the body of the print. So when it finishes the Z level for the supports,...
When I got to layer 95 after changing every line of code there was no "G0 line with the .3 less on the Z. G0 F600 X521.04 Y1557.375 Z38.4 G0...
I found an older version that does not do this. It keeps the supports the same level as the part. Then later adjusts to allow separation of the parts. Jim...
I wanted to have the space between the part and the supports at. .3 mm. Because My first part with .1 mm was impossible to remove the supports without a...
Every time after the first layer it jams. It rises about .1 mm instead of the .4 mm layer setting. And it puts a .3 Z height lower on every...