Arducam Support

Hi, Did you connect the Arduino Nano 33 BLE to the camera via the dupont wire? The length of the line on the impact of serial port signal is particularly...

Hi， We don't have Spresense board, so we can't test it for you, but you can paste the error message and we will try our best to help you analyze...

Hi， We have modified the library file to compile and pass your above demo, but since there is no board, it is up to you to test it. What needs...

Hi, Please check whether the SPI pins of the board are consistent with those used in the demo.

Hi, The pin definition between arduino uno and spresense board is different, you should accroding to the real SPI and I2C pin to change the wiring connection.You may also need...

Hi, Your picture upload may have failed, I can’t see your picture. If the connection is correct, the main reasons for the SPI error as are follows: 1. The SPI...

Hi, Do you mean that the TFT screen has been successfully driven using the same SPI line? This seems to indicate that there is no problem with the SPI line....

Hi， You can first use the SPI method in the RA8875 library to read and write the camera's SPI register, if the read and write succeeds. Then you can refer...

@joehowarth17 Hi, We wrote a MT9D111 camera example in ARDUCAM_SHIELD_V2 platform, due to the jpeg images can't directly to the LCD, so to save images to the SD card, you...

Hi, **Image Corruption**:This is usually caused by the SPI speed being too fast, or the wire is too long. **Data Handling**：Before the image is read, it is stored in the...