ADD new target DAKEFPVF405

Open engineer-dakefpv opened this issue 7 months ago • 4 comments

We tested the DAKEFPVF405's autopilot mode and it looks like a success.

May 18 '25 12:05 engineer-dakefpv

@Hwurzburg @peterbarker

May 29 '25 05:05 engineer-dakefpv

@Hwurzburg It has been amended as require.

Jun 02 '25 07:06 engineer-dakefpv

I have modified a couple of things that were obviously wrong. Note that you do not have and cannot get DMA on your RCIN because that channel is being exclusively used by your motors. You may therefore have issues with CRSF and ELRS. I tried putting bdshot on but it requires too many DMA channels. I think the DMA setup is hard for this board and probably what you have currently is as good as its going to get.

Jun 04 '25 16:06 andyp1per

moved the UART protocol defines, added relay default params, cleaned up the readme.....squashed, and library split....should be good to go to devcall...

Jun 04 '25 19:06 Hwurzburg