AM32-MultiRotor-ESC-firmware

AM32-MultiRotor-ESC-firmware copied to clipboard

I want to make it from hardware,but i can't find the hardware design.Plaese

Enola-liu

added RGB LED, including a blink pattern engine it uses the 10 kHz routine, but the blink pattern is executed at 100ms time frames I have defined some patterns. The...

frank26080115

Hello, used on the ESC of a quadcopter drone, the motor is 110KV, 21 pairs of poles。 the "AM32 MultiRotor ESC firmware" program. What configurations would you recommend?

AkunEverson

Contact administrator

1

Hello, please tell me how to contact the AM32 administrator and where to find your contact.

Zxx-Eric

is there a list of cli commands for configurator to set them by cli?

7

docjones82

I had a hard time reading the source code and clang-format made it much easier for me. Here is a PR for a simple script to auto format the project...

noiuynoise

No Temperature Limit Celsius, and no Current Limit Amps

2

Hi Folks, Im not found any Temperature Limit Celsius, and no Current Limit Amps on Input Tab. And can I set motor to free wheeling (without any break at all)?...

ariefadha

How to use hall sensor on AM32?

2

There is options “Use Hall Sensors”，but how to connect the hall sensor to ESC? Is there any guide about hall sensor?

ansmax

I successfully compiled the F051 hardware on the stm32cube ide. How do I configure the G071 chip? thanks!

366563421

Add new Dshot commands to configure ESC settings.

12

The usefulness of changing ESC settings is becoming more and more common knowledge. The ability to change esc settings using the FC configurator or OSD will make testing setting changes...

Quick-Flash