5ocworkshop

I have a fairly large machine, my X is over 1100mm of travel. In going through detailed calibration after moving house and taking the machine apart, I discovered I needed...

New Keypad integration wtih IR Remote

9

Terje, Not an issue, just wanted to say thank you for the changes to the keypad.c plugin. Thanks for your recent updates. I was able to set it for keypad...

Proposal: API for secondary inputs in to grblHAL

26

Terje, I'd like to propose the idea of an formal API in to the grblHAL core via an official plugin that defines the functions available, applies restrictions and safety checks...

Suggestion: Always trigger State change on boot/reset

14

I am working on status lights for my machine and if the machine comes up in STATE_IDLE, it does not appear to fire the onStateChanged event. However, if it comes...

Y offset input box - difficult to enter negative number

1

I recently moved my machine and had to resquare my X axis so I needed to put a negative value in the Y-offset box. I was eventually able to do...

Req: Macro support and 3 point circle center finder

5

Hi Terje, I started using some great macros in CNCjs that I'm hoping you might be able to incorporate in to IOSender. They are found here https://github.com/chuyskywalker/cncjs-macros and they find...

Is it possible to buy a fully assembled board, either with or without the Teensy 4.1? If not, is it possible to have one fabbed with the available files? What...

REQ: Option to enable timestamp prepending in console feedback view

8

Thanks again for all the great work on grblHAL and IOSender. I was working with some folks on the PrintNC Discord today investigating some odd behaviour around spindle on delay...

Soft-limit changes can cause dangerous misunderstanding due to homing required, suggest alarm on enable or change to axis length

2

Over on the PrintNC discord we've been helping new users get their grblHAL boards up and running and a recent discussion highlighted the current behavior around enabling soft-limits. As noted...

REQ: Break re-factoring down into new additions and then removals.

1

.22 is really great, but gpt4 still struggles with breaking larger functions down in to smaller pieces as it tries to make very large diffs and fails. I have had...