5axes

hereafter a basic test  - Left part : Your gradient Infill ( 2D) without speed variation, the infill width variation is hard to mesure. - Center part : same...

Yes, With my machine (Ender 3) **without direct drive** default settings line width : 0.4mm so the expected width should be for 200% 50% -> 0.8 - 0.2 - 0.8...

Without a direct drive, The speed reduction must be (in my case) proportionnal to the Flow variation. In my test the width of the line close to the border is...

Yes you're right the main issue comes from the limitation of this type of extruder to deliver 200% at the normal infill speed, but it's not because it's a bowden...

As someone as already write : Faster than the light !

I think I need a little bit more explanations . - None : Ok it's clear the Infill speed is used everywhere - On Flow Change : It's the previous...

Tabs are considered as support and the parameter **Support X/Y Distance** is also used for these elements . Due to a Cura limitation the **Support X/Y Distance** fixed on the...

Well It's the same base, but I added some "Automatic function" to remove or add the tabs on a part.  But basicaly the shape of the tabs and you...

The original request on Cura Github https://github.com/Ultimaker/Cura/issues/12426

Could be an issue with Cura , Not with the plugin . And As I don't have any issue it should be something in your settings but without additionnal information...