53Aries
53Aries
After updating Klipper, mainsail, moonraker, everything a few days ago and updating my Klicky probe macros.cfg the printer no longer attempts to attach the probe when using the mainsail homing...
During homing sometimes the current will be dropped to the defined value and other times it wont. When it does not, the console displays the typical message of "Run Current:...
If I issue G28 the X axis will home but not the Y and then it attempts a probe attach. If I issue G28 Y it will home Y. It's...
Unable to flash via STM32Cube. I am able to flash klipper via STM32Cube, but katapult fails. Reference attached screenshot. 
Would not flash no matter how I tried. After removing 35 from the file name it flashed.
I'm trying my hardest and searching I promise. I'm trying to flash via usb in dfu mode. I configured per the v1.2 manual. Device shows as STMicroelectronics STM Device in...
Katapult does not support the make flash command. Attempting to use STM32CubeProgrammer results in errors and unable to flash. 
Just fyi. Thanks.
I know this isn't exactly for the Q1 Pro but fyi. Everything works following the instructions but the LAN port goes dead. If I unplug the toolhead board LAN comes...