Valeriy Novytskyy

No rule to make target x64

3

Hello, I am following this tutorial to build dynamixel workbench on Raspberry Pi 4 (Raspbian) and ROS Melodic: https://emanual.robotis.com/docs/en/software/dynamixel/dynamixel_workbench/#linux-and-macos Getting this error after running "make": ``` No rule to make...

Setting up tests with preact-cli project

4

Is there an article on setting this up with preact-cli created project? I have no doubt you are very busy so I will keep hacking, but if you know what's...

// cast - suspendaslurry hip left hip right chest base shin shockplate left shin shockplate right // cast - ultravest hip bottom connector left/right - one of these missing spine...

Report from https://www.thingiverse.com/thing:2205658/comments/#comment-2028876. It turns out Pelvis Mount Stem doesn't have a cut deep enough to allow Pelvis Mount to be inserted and align the mounting holes.

Create 3.5 flask fixture

1

* Get pipe with 3.5" 2" h inside diameter from Eastside Steel or Clackamas Steel * Weld and machine the fixture * Apply refractory if necessary

Steps 1. Design, produce and finish the model 2. Design and produce silicone mold 3. Cast and prepare the wax model 4. Invest the wax model and perform burnout 5....