Zachary Konkel comments

Results 16 comments of


                                            Zachary Konkel

add_segments() should know about z coordinates

trying to bump this - would be beneficial for fitting vectors on 3 dimensional ordinations

add_segments() should know about z coordinates

Can someone with knowledge of the code explain why implementing a z-axis has been avoided? This functionality exists in other plotly commands, so it seems that this is an intuitive...

Clinker just stalls without producing output?

to note this for others, my assumption is you are running out of RAM

Unable to connect to ProtonVPN: Exception: NM.Client.activate_connection_finish() takes exactly 2 arguments and VPNConnectionStateEnum.NEEDS_CREDENTIALS - Reason: VPNConnectionReasonEnum.NOT_PROVIDED

the dependency web is nearly impossible to navigate for arch. I had to install several independent pypi packages, sequentially install 4 different protonvpn dependencies, `nm-applet`, activate `NetworkManager`, AND STILL DON'T...

mRNA created for misc_RNA or tRNA or RNA and reported as duplicated by the ENA validator

I second Juke34 here for two reasons: 1. removing mRNAs from prokaryotes messes with interoperability with eukaryote gffs in downstream software, it's poor file formatting standardization. The GFF is a...

General CI failure in lint due to Azure error `No hosted parallelism has been purchased or granted`

getting this error this morning: [#47804](https://github.com/bioconda/bioconda-recipes/pull/47804/checks?check_run_id=24911971977)

Add mycotools

@BiocondaBot please add label

ERROR: Tree taxa and alignment sequence do not match

sporadically get this error, reappears if I try to resume a run that was initialized with --keep-ident

Must restart system to switch to nvidia

It has the same effects with the default config

IMPORTANT DEPENDENCY VERSION INFORMATION

Because OrthoFiller is not being maintained, I've updated the program to work with modern software versions (except BedTools) and increase sensitivity. Please check out https://gitlab.com/xonq/OrthoFiller for more information.