ttpilot

> At this time, the TE_ANSI editor is running for 8080/z80. I am holding off the total commitment until I can test the code on my 8080, its about 10...

I'd like to try them out. Think of me as a beta tester lol. I thought about going through Miguel's source code myself, but I haven't done any CP/M programming...

I'm using te on an Altair 8800c with TeraTerm as a VT100 terminal. Te seems to load okay and shows the editing screeh, but it doesn't respond to pressing ESC...

Thanks. I'll give it a try

I tried it out. It sets up correctly on the screen, and typing text works fine. Any text I 'Save' or 'save As' appears to write out to the disk,...

Never mind. Disk was full and produced no error message. Te is saving normally. Thanks much

Understood. I thought a bit about that today. It's been too long since I used a lot of control-key codes.