Michael P.

>Window 24 ms: Average 1.034 mA, Period (adv.impulse) ~2 sec, Deep-Sleep 6 uA (1.034mA * 24ms + 0.006mA * 2000ms) / 2024ms = 0.0182 mA plus energy of one advertising...

>It is also necessary to embed a GPIO ("reset" mark on the board) trigger for the assigned temperature / нumidity... + loop recording for a month in flash... What do...

I have used your repo again ;) Have you tried the OTA firmware update? I have some problems here (using your flasher page) At first flashed from original FW to...

>Write there... Reload 'cstartup_825x.S' (there was a previously changed header) There are no issues enabled in the repo ;)

> `Device: Name: ATC_9D4132, Address: a4:c1:38:9d:41:32` Isn't it the device you are looking for ? ;)

I use some of these sensors and have no problem with receiving advertising data. You must not connect to device for this - all will be transferred without connection. You...

@meierthomas You can read all information direct from advertising string. Only battery information will not be send here. The sensor does not send all information at once, but each parameter...

it seems to be a question of decoding there... Using OpenMQTTGateway all is fine: ``` Dec 7 13:35:35 espressif.fritz.box - O_MQTT_GW-1 - - - Received json : {"id":"C4:7C:8D:6B:66:20","name":"Flower care","rssi":-84,"distance":13.81901,"model":"HHCCJCY01HHCC","fer":1586} Dec...

You can use the blinking by default. If you will disable it (by Web UI or compiling with other flag) then the standard function will be enabled. Second is an...

I have checked - "blinking" or any LCD update seems not to be critical for battery usage ;)