James Armstrong

If it is related to anything I have seen, then it is because you manually extruded and then resumed without setting the E value back to 0 in the menu....

That is what I have already (on SD). It is just something the old firmware had built in but I hate Marlin and it was just not working out so...

That is exactly what I am looking for. Thanks. Just an easy way to "level" the bed they way it should be before enabling the Auto Leveling with probe. I...

Understood. I just forked the Repetier repo so I can start merging in your bed leveling changes for me to use. I should be able to find the parts needed...

I would think the filament diameter must be used if Marlin has any type of dynamic diameter control feedback since usually the printer firmware doesn’t care because the slicer is...

I am getting past the exception, but what I am seeing is only part of the memory is being freed when I delete the trap. So the memory leak will...

Same here, was just looking for this solution.

No rush (I have the 2560). Just tried it a few times and everything moves the wrong direction and crashes. I just have to remember not to do it. Like...

I have the new washer dryer combo and would also like to see the missing values for the Softener Tank (instead of just the detergent tank). I will read on...

Is there any way to use the esphome normal display: section and the normal text, ui drawing elements with this setup? The only thing I see is the two hardcoded...