core

core copied to clipboard

Progress with STM32H7

24

Hello Terje Io and All. Same question like in #88 I want to use BTT motherboard with STM32H743VIT6 cpu. How about progress with STM32H7 ? May I help you some...

Demitrius

SAM3X8E Ethernet

1

Is it possible to connect grblHal with the Arduino Due board via Ethernet, and improve electrical noise problems? Ethernet is not in the SAM3X folder. Is Bluetooth a good option...

MARIOBASZ

I have a fairly large machine, my X is over 1100mm of travel. In going through detailed calibration after moving house and taking the machine apart, I discovered I needed...

5ocworkshop

Found via`codespell -q 3 -L iterm,nd`

luzpaz

Some drivers(like esp32) don't set hal.spindle.update_rpm, then giving a crash when overriding the spindle

Erik-Morbach

How often an Aux input can be used?

4

I see in the code there is support for Aux Inputs, I want to know what would be the case where I would need an Aux input in the controller....

muhammadelmogy

G5 cubic spline

4

https://github.com/grblHAL/core/wiki/Changes-from-grbl-1.1 I think fact that G5 supported should be reflected there. My dream is to see G5.1 and G5.2 one day for Quadratic/NURBS Spline ;)

kimstik

Feature request: Preconfigured PlatformIO support

8

I'm coming from Marlin, which compiles in VS Code out of the box, and have no experience using C compilers beyond following the occasional how-to. Is there anyone who can...

Domush

$37 - Stepper deenergize mask dont work

2

Hello im try to disable deenergize in some axis, but only works in all 3 axis, is the mask work correct? I use iMXRT1062 with T41U5XBB board. and enable pin...

gendebeat

IOsender configuration backup breaking gbrlhal permanently

1

I was having many weird issues on my Grblhal2k board + IOsender. spindle out would not work (properly), random crashes etc. Re-flashing etc did not help. Tested hardware using simple...

Tsillen