dodox1

I have ts100 pcb version V2.5**B**. ~~here is R1 value 850k, unlike version 2.5**A** where the value is R1 750k. Do you think this should affect the temperature reading? (R1...

OMG, sorry it is EIA-96 marking :see_no_evil: so the R1 value is the same 85D = 750k (It was from aliexpress in 2019, but seems to be original package)

TS100 V2.13 test with tip BC2 (room temp calibrated) set - measured 200 - 197 220 - 218 240 - 238 250 - 248 280 - 279 300 - 300...

Did You see this "china" T12 controller board based on STM32 as inspiration? There is in a few different HW version (2.1S, 2.01 and 2.0) Reverse engeniered: https://github.com/jomat/stm32_soldering_iron_controller/tree/master/schematic

It seems to be necessary to update the SDK "SDK v12.3.0 provides experimental support for the nRF52840 SoC" *** Scope for the nRF52840 chip ******************************** The PCA10056 development board is...

Just now, I found this... https://github.com/OpenSourceEBike/Color_LCD/blob/master/firmware/SW102/Makefile_NRF52840

Update. It seems that nrf52840 is not a big problem to convert to the newer SDK (16). (Just a few modifications of some changed API calls) For testing purposes, I...

This is my test print with scarf joint seams activated. I tried to modify the G-code (line 3581 and few next layers): ... G1 X102.71 Y112.381 Z2.8 E.00008 G1 E-1.5...

But this is a different problem than what I described.

What I showed is not that the nozzle travels through the printed material, but instead travels upwards on the spot.