bdring

The option to output DAC or PWM might make your board more flexible to use other speed controllers. invite sent

My branch only writes in daisy chain mode. I worked a little on daisy chain reading, but never finished it. Setting up stallgaurd is tricky, especially if you have long...

Have you tried using those with 3.3v? The resistor is pretty high, so they might not light up. 5V will kill an ESP32

I have used these switches. They work fine for close on contact if you use the red and white wires. They will light up at 3.3V. The resistor appears to...

Can you draw a quick sketch or markup a picture of the controller of exactly what you want each stepper motor to do? The resolution setting controls the step to...

This is the project I am working on. It works great 99% of the time, but sometimes the touch quits. https://www.youtube.com/watch?v=mg1y1k8I-8s

I have an xPro. I do not have it hooked up right now. I don't have time to test your file today. We have a wiki page for it that...

I do not know why your start messages show a probe defined, but $probe shows no pins. I just tested on 3.7.15 and my probe loads and works fine. We...

Something has changed for the better. Send a picture of you probe and the connection to the controller. Also send "?" with the probe activated, then deactivated. Paste the responses...

Try using a piece or wire to complete the circuit. Then request status with ?