TheWebMachine

As I said, I installed it via `pip`. No errors or issues when installing, only the ImportError when trying to run it. Perhaps the PIP repo copy is missing `utils.py`...

Arm/Disarm status still not updating properly for me in 3.0.3. If I manipulate from HA, it updates status. If it is armed/disarmed elsewhere, the status never updates and my automations...

Ugh...forgot 2.2.2 was funky, too. I'm rolling back to 2.2.1 until v3.x is resolved. Between 3.0.3, 3.0.2, and 2.2.2, I've had 3 false alarms incidents on my system because of...

> Use v3.0.4-beta.2. There's a bug in beta.1 that ignores user-entered polling intervals. So far, so good. A little over an hour into updating. I have my polling set to...

Are you on the latest 3.0.4-beta2? Arm/Disarm from within HA is under 5s for me in the latest beta, regardless of polling interval.

I, too, am interested in laser support. What all would have to be removed from the Ender3S1-F4-UBL firmware to make room for laser support? How thin are we on space?...

> Found a solution [here](https://github.com/esp8266/Arduino/issues/2281#issuecomment-258706478) for the conflict between File class defined in FS.h and SD that does not require any changes to the Inkplate library. > > As shared...

> > > I can comfirm that "something" is very off with the CR touch. (Ender 3 S1, F4 controller) Semms to be the bigger the Mesh the bigger the...

Welcome to popularity! Not only does everyone and their grandma know about Flipper, now even Grandma is using one...and wants help from yooooouuuuuuu! 🤣

I haven't had this problem at all. 🤷🏻‍♂️ Maybe you just have a faulty unit? Edit: I have 0045