Rob Smith
Rob Smith
Ok, something to try, it may seem unrelated but may fix the issue. In _CommonBridgeTemplate.cpp_ line 288. Change the line `queueReady = m_driveResetStatusFlag.wait_for(lck, queuePause, [this] { return m_queueSemaphore > 0;...
@svenson-a did you uncomment the queueCommand(QueueCommand::qcResetDrive); Line as well? You don’t mention you had
Hi, tbh I’m not sure, I suspect not directly. I suspect the code would need modifying for a different bit-rate
Hi, first you always need to power up the Arduino first as (as you suspect) it will power up from the 34-pin connector, and not always in a good way....
The issue after enable motor usually means the drive is pulling too much power, which has caused the 5V to drop too low and as a result the Arduino has...
The ATX power supply shuts off?
IF the power supply shuts off it will mean overload or short circuit.
Looking around, and I don't know which model of BBC drive you have, but some of them can peek at 1.2 amps on the 12v
I suggest you try to get the disk spinning without the arduino for the minute, sounds like theres a issue there somewhere. The Error you get from the software is...
Not much I can help with if you are having power issues im afraid