Per Mejdal Rasmussen

I could not get 5Ghz to work. After reading this post I change the channel to 36, and it now works. Thanks.

You might find the infomation in the guide usefull, even if it in Danish: https://drive.google.com/drive/folders/1SMhPC1echgKWlc-W4N89JKZ2KiJ_H_ZD It tells how to use JTAG to dump or flash the ZigBee module.

> And I managed to apply the changes to a normal pc with stlink-v2, and now I have a working remote with the zigbee module from a bulb.... Can you...

I was told the new module would spend too much power. Why else is it using 2xAAA... Maybee I sould give it a try. 

First release of STYRBAR to Danish wall switch is now released: https://www.thingiverse.com/thing:4938961 The idle power consumption is the same. 

Diagram 

In Denmark STYRBAR is 69 DKK, whis is 9,28 euro. The nye E14 is 59 DKK, which includes the new module. The module alone is about 100 DKK. Reprogramming the...

The TACH switches are different on my PCB.

Hi Oliv3r I am now using your KiCAD footprint of the ZigBee module for my project. First i design my own, which was a little wrong. Then I used basilfx's,...

The footprint basilfx has made is about 1.1mm too long, and was almost usable. I made a correction, which is only 0.1-0.2 mm too long. Your footprint is a little...