OpenBuilds-CONTROL issues

No way to connect via wifi on FluidNC

I could not find a way to connect via websockets on FluidNC. Is this planned for a future release?

Install broke

The install broke, seems like the same issues I had with the latest electron build...something is up You can view the relevent issue here: https://github.com/electron/electron/issues/35193 `⠸ Building module: bindings, Completed:...

JiMcNulty

Probe offset vs PRB

As discussed with @sharmstr via PM - can improve accuracy https://openbuilds.com/conversations/probe-result-differs-from-position-offset.12543/

petervanderwalt

On disconnect, reset status:{} to some cleaner, saner defaults

2

As per @sharmstr suggestion: "I think what threw me off is that its not setting the DROs back to 0 when it disconnects"

petervanderwalt

To be tested at some point, sounds like an awesome feature

1

petervanderwalt

Add z-index to #completeMsgModal

2

Add a z-index value to #completeMsgModal so its always on top of other dialogs. I'm working around it, but probably wouldnt hurt to have it in Control.

sharmstr

Toolchanges

54

Normally you'd want the GCODE to have M6 (Pause) then a Tx command. The UI should pause streaming at the M6, and prompt you to insert tool X. Then you...

petervanderwalt