Installation troubles

[wpmccormick]

I had some problems getting this.

First, making the 45° cut; I needed to shave off little pieces at a time. I think it would have been easier with a Dremel tool.

Then, trying to attach the mount, it ended up cracking while putting in the screw. In the end, I just super glued the whole thing. I think a better design would make gluing something on without needing to cut anything would work better.

In the end, the bottom of the probe is not completely level along y-axis. I don't think that's an issue, but wanted to check if I need to consider redoing the whole thing.