zitev
zitev
Hello @markky10, yes, this was typically the case for me, and the cause is most likely a power failure! I looked it up, unfortunately I misremembered when I memorized the...
A possible problem could be if the supply circuit is unstable (dried capacitors, low supply voltage, etc.), so the base machine may still be running, but faults will already occur...
I am repairing an Assy 250469 Rev.3 motherboard right now, i am experiencing similar uncertainty with the KFF, at first it was as if the T1 capacitor trimmer was affecting...
This is a good question, first of all it is worth checking if the T1 trimmer is tuned to the correct frequency (14.31818 MHz on pin 8 of 8701)
Hello Kim, How accurate is this diagnostic tool? I set it up with an oscilloscope, and compared to that, this kind of method shows a little difference, I had to...
Hi, On the c64 panel, after replacing the T1 trimmer capacitor, I set the PAL clock signal to 14.31818 MHz as measured by a scope on pin 8 of the...
Hello Arcahell, The T1 trimmer is visible around the center of the motherboard, a tiny, lemon-yellow, adjustable capacity. You can adjust it with a screwdriver that fits exactly into it,...
If porting is already the topic: how easy (or problematic) would it be to port KFF to Plus4?
Hi Guys, I have also the same problem, "Looking for HDSP cards : Card 0 : RME AIO S/N 05844591 at 0xf7ef0000 irq 16 No Hammerfall DSP card found." alsamixer...
The problem is the same with me, I see that it has not been solved since then.