EFI-for-X1C6-hackintosh icon indicating copy to clipboard operation
EFI-for-X1C6-hackintosh copied to clipboard

Published 20 hours ago • verified publisher icon zhtengw

system launch debug mode removal

Open threerocks863 opened this issue 4 years ago • 4 comments

There's lots of debugging messages print out during boot session, I try to find -v in config.plist, but it's not there, but "keepsyms=1 -v" always appears on boot menu 21589549054_ pic

threerocks863 avatar May 15 '20 13:05 threerocks863

The boot args may be saved in your nvram. Press F11 in the Clover interface to reset NVRAM would clean up these args.

zhtengw avatar May 21 '20 01:05 zhtengw

Seems still not working, I looked into clover configurator nvram, the boot arg always has debugging info as above picture shown, but once I removed, it came back again...

Do you have any idea of this, thanks.

image

threerocks863 avatar May 23 '20 01:05 threerocks863

You could try nvram command. Run sudo nvram -d boot-args can remove boot arguments.

FYI: Is there a list of available boot-args for darwin / OS X.

zhtengw avatar May 23 '20 02:05 zhtengw

Thanks for your idea! I ran the command sent to me, but seems not working, then I did some investigation online and turned off SIP and tried to set boot-arg empty(recovery mode), but system Catalina disallowed me to do this, I don't know if I need to set other parameter off before set boot-arg.

image

threerocks863 avatar May 25 '20 01:05 threerocks863