WiringOP
WiringOP copied to clipboard
zhaolei
This is a GPIO access library for OrangePi. It is based on the original WiringPi for Raspberry Pi.
Hello, Please, add support for Orange Pi One Plus (SoC Allwinner H6).
I'm getting `piBoardRev: Unable to determine board revision from /proc/cpuinfo -> No "Revision" line -> You may want to check: -> http://www.lemaker.org/`
The compilation is completed with several warnings, when you use the command gpio appears this message : gpio mode 7 in piBoardRev: Unable to determine board revision from /proc/cpuinfo ->...
Not working gpio readall piBoardRev: Unable to determine board revision from /proc/cpuinfo -> No "Hardware" line -> You may want to check: -> http://www.lemaker.org/
hi how should I use WiringOp on Officially android for orange pi I added this library to my android project and built that with NDK and run on my orange...
I tried it for orangepi 5B and I am getting the following error . [sudo] password for orangepi: piBoardRev: Unable to determine board revision from /proc/cpuinfo -> No "Hardware" line...
After installed Ubuntu image and downloaded & installed WiringOP, the "gpio readall" command does not work properly. After printed part of table header, there is an error message: Orange Pi+-[...
When booting an Orange Pi the default pin state appears to be HIGH. On a Raspberry Pi there is a `/boot/config.txt` file to change the initial boot state. Is there...
