Stuck in predicting connectivity when running quick_start.py

[Learningm]

Hi, when I run quick_start.py, it seems stucking in predicting connectivity step. I tried several models but I failed to pass thourgh this step, shown as following pictures. Could you please figure out what's the matter? Thank you very much.

[zhan-xu]

Hi could you check how many joints you predicted? This sometimes happens when the code predicts too many joints, which perhaps because mesh is not normalized or the bandwidth and threshold are not proper.

[viqsoul]

I had the same problem wen i tested:model_id, bandwidth, threshold = "17872", 0.045, 0.75e-5