Błażej Szczygieł

Hmm. I experience it on HDMI when HDMI is in... power-saving mode? One it wakes-up, it plays normally, but usually I lost begin of audio. Maybe same with bluetooth? Is...

> QP2 playback uses an "ALSA Plugin" I think for PulseAudio you should use PulseAudio plugin. ALSA is for `hw:` or when use use their `dmix` (no need to use...

> it certainly doesn't interfere with QMplay2's correction QMPlay2 corrects A/V sync only. --- You need to add about 0.5 seconds silence on playback start (when your audio device is...

> Still, after some more testing right now it does seem like the PA latency offset is to blame?! Latency in pavucontrol shouldn't be used for your issue. It may...

> Meanwhile, my BT device is seen as a USB DAC by the system, and the LEDs on it go a bit duller after about 5 seconds of not receiving...

> You don't understand my words or what I describe? On your internal sound - are you adding latency offset in pavucontrol? Do you have any issues when you don't...

> Even if you pretend the video also starts with the same duration of something else - say a dissolve effect of the rest screen? Video needs to be informed...

> Nothing to do with delays or latencies, but I just read that PW resamples everything to a "central frequency" and from there to whatever the output device is set...

Try this command `watch -t -n 1 cat /proc/asound/card*/pcm*p/sub*/hw_params` and see sample rates - it comes from audio driver. Also open `pw-top` - it shows what PipeWire is doing with...

> That's what I'd hope too, but I suppose it depends what that internal frequency is - probably not 2116mHz (44.1k * 48k) ;) What driver or hardware is doing...