yaapu
Jumper T15 Support
Tried to load yaapu telem onto my new controller jumper t15 and its not working.
Hi, T15 should work just fine, I tested on an actual radio, I suspect the issue is elsewhere, like configuration or proper ardupilot configuration, please describe your setup with edgetx version, ardupilot version and widget version
It works fine for me (testing it very recently) Assuming you're using ELRS, did you enable CRSF from the yaapu config? You also need CRSF telemetry passthrough from the RC_OPTIONS parameter
Well, looks like there's some more complexity to this. It was working when I was on EdgeTX "Centurion" v2.10.6 When I updated to EdgeTX "Jolly Mon" v2.11.0 it stopped working The switches on the T15 used to indicate charge percentage while charging but that also stopped working. I suspect there's a bug in the EdgeTX firmware itself for this radio. I have now reverted back to v2.10.6 and will stick with it.
More details if that helps:
On EdgeTX "Jolly Mon" v2.11.0 the screen 1 works and I can see the model tilt and mode change announcements but nothing on the Ardupilot messages (INF/DBG/...). Sometimes the screen would even freeze which was a bit worrying.
I also got Emergency Mode on the radio once. Not sure what caused it.
I verified my setup on EdgeTX "Jolly Mon" v2.11.0 and changed nothing on the Ardupilot side but it didn't work.
First screen sort of works. No Ardupilot messages.
Second screen never worked. Both screens complained about No Telemetry every now and then
I did have telemetry
I tried increasing telemetry rate and packet rate
Hi, edgetx 2.11 switched to Lua 5.3, my script is written for lua 5.2 and needs a full rewrite