Renzo Mischianti

Hi, If I remember @fixajteknik use idf with my library. I don't have experiences with it. Bye Renzo

Hi, the configuration works only at 9600; you must split the sketch in 2. Bye Renzo

Hi Wross, It's strange, it seems that the size of the variable was different from the devices, but you use primitive type that can't generate that problem. Try to send...

Mmm.. I think It's broken; try to connect as Serial and use the EByte program to reset. But I think it isn't useful. Bye Renzo

Hi, It seems, that there is a wiring problem. The device not move the AUX pin. Bye Renzo

Hi, I use that information to show on the web interface  There is any problem with some devices?

Hi Emiliano, sorry for the late response, I.m going to add a define to remove It, and if you need It I generate a specified bin file. Bye Renzo

Retry the installation process. Then try to install BeePrint 1.5 and MKS_WIFI 1.2. Bye Renzo

Hi all, It's possible that you don't use the original firmware? People also test the device on Ghost6 (with the same MB version) and works. Bye Renzo

We continue on the forum, and I need the correct baud rate perimeter to make the correct choice. [Topic about this](https://mischianti.org/forums/topic/printer-not-connected/) Bye RM